Blog

Once logged into the wireless controller, creating a WLAN is very simple. Configuring the WLAN’s setting is where it can become difficult. Creating the WLAN is as easy as entering one command in configuration mode. That command is the wlan command. In this blog I will be covering some basic commands for you to create and configure some general properties of a Wireless network.

Recently I captured a Wi-Fi survey for a customer. While looking at the data in Ekahau. I noticed a small area that had lower data rate than the rest of the building. While trying to figure out why I checked the normal suspects like signal strength, noise, signal to noise ratio, co-channel interference, and channel width. The data from these categories all looked good and there was no clear...